By Syahrul Fithry Senin
First of all, you should give a quarter of the full perplex geometry as shown in below
Then select Attribute->Mesh->Surface and choose Thin whip element (if thickness/ drawn-out length < 0.1). If your thickness/longest length > 0.5, use Thick Shell
I assume that the shell has t/L < 0.1, so i choose speculate Shell Element. For preliminary meshing, I will use quadrilateral mesh with 4 x4 division meshing. I will named this settings as mesh 4 x 4
award the created start with ur common mackerel and the surface will be darkened as shown below
Select the mesh settings on the left side with ur mouse and check over that the surface has beenl selected (still dark), drag and drop the mesh 4 x 4 to the darkened surface.
The surface will be operate by 4 divison and 4 division in right direction.
Using this mesh scheme, u may see that the curvaceous portion of the original shape was not connected by curvy lines...but in install to increase ur accuracy, u use up to use finer mesh .
Select the whole surface and right click and pick copy. Under copy negotiation box, pick rotate and input the angle to be 90 degrees (-ve rotation) and input the origin of the rotation to be x =0, y=0, z=0
Change the number of copied surface to be 3 times and click OK
Walla. You just created a 3D aeronaut shape with 4 x 4 mesh in each quadrant.
Regards
Syahrul Fithry Senin
UiTM PenangIf you want to get a full essay, order it on our website: Ordercustompaper.com
If you want to get a full essay, wisit our page: write my paper
No comments:
Post a Comment